Impressed Current CP
Impressed current cathodic protection (ICCP) has been used successfully on the atmospheric zone of structures in Australia for over 30 years. The first system was installed under the direction of Frank Papworth, SRCP’s Chairman, on Bridget Beach Apartments in 1984. Since then ICCP has been used on hundreds of structures in Australia. They remain the most common CP system for atmospherically exposed concrete.
Sacrificial Anode CP
Sacrificial anodes have been used for nearly 20 years but not for cathodic protection. The anodes available had low driving power and were only suited to cathodic prevention. A patented range of anodes for cathodic protection has been available in Europe for 10 years and these are now available through SRCP in Australia.
When corrosion of reinforcement in concrete first becomes apparent as isolated concrete cracks or spalls it is often an indication that environmental contaminants are more generally reaching the reinforcement.
If left cracking and spalling can become wide spread within a couple of years. It is important that apparent cracks and spalls are repaired and some form of protection applied to all concrete. Very often it will be too late to apply barrier coatings as the contaminants will have already penetrated the concrete. ‘Break out and patch’ is a commonly used repair method but it is often too expensive to be undertaken over all areas of contamination, and where it is it can be disturbing and create structural issues.
It has long been recognised that cathodic protection is the ideal repair method in that it can stop reinforcement corrosion without the need for breakout of contaminated concrete.
Impressed current CP is suited to major structures where the owner can afford the relatively high design, installation and maintenance cost and the deterioration must be halted over a long design life, e.g. 50 years. Sacrificial Anode CP is less expensive and requires less design and maintenance. It can be installed economically on small structures by relatively inexperienced installers but the anodes generally need to be replaced at 15-20 year intervals.
There are various impressed current and galvanic anode types available. All have their place and it is the suppliers responsibility to advise which anode type is most suited to a specific application.
Asset Inspection: Aerial Photography
Thanks to our close working relationship, SRCP now offers an aerial inspection service for the construction industry in Perth, via drone aerial video inspection from Pixel Pilot.
Pipe, Tank and Steelwork Corrosion
Hot Dipped Galvanising (HDG) is recognised as one of the most reliable corrosion protection systems available. Unfortunately once it starts to break down it cannot be re-instated - until now. Zinc Tape can be applied to the steel surface and provides better corrosion protection than the original HDG.